Anderson - MF Kustoms Holley Terminator X Max Kit 1994-1995 Mustang GT w/ AODE

For 94-95 Mustang GT with AODE/4R70W Transmission

Cut down and simplify your installation with the NEW Anderson - MF Kustoms Holley Terminator X kit for the pushrod SN95 Mustang!

AT LAST!!! A Terminator X kit designed for the 94-95 Mustang is here! Anderson Ford Motorsport has partnered with MF Kustoms to create a Terminator X kit that not only simplifies the installation process but also cuts down your labor time by nearly 80%! The key is the MF Kustoms plug & play adapter that plugs the Holley Terminator X into the factory EEC connector in the kick panel. This feature alone saves you a ton of labor on your installation. Not only that, the included adapter harness allows you to plug the included Bosch 4.9 wideband sensor to be used in the system. This system allows you to keep your factory wiring harness in tact and allows you to return everything back to factory if you so desired. The system is already pinned out properly for use with the factory Ford IAC motor and factory air conditioning if equipped. No messing with the CCRM is required! Another excellent feature is the dual CAN connections built into the harness to allow use for a 3.5" touchscreen handheld (additional option), digitial dash, and CAN-USB adapter (included) without needing an additional CAN splitter harness. All Holley Terminator X functionality remains the same tuning wise via the software and handheld (if purchased). Software and firmware updates are all available through Holley's website. This kit is the perfect solution if you have a great condition factory wiring harness.

Note*

You will need to setup some configurations for the system to work properly with the 94-95 factory components on the Holley software. See the link below on step by step instructions on how to set these up!

Link for configs

This kit comes with everything you need to install into your 1994 or 1995 Mustang GT. (Pushrod 5.0L/5.8L based engines)

Sub harness has the following connectors:

• Fuel Pressure
• Oil Pressure
• Manifold Air Pressure
• Flex Fuel

Not CARB certified or EO compliant, for Off-Road use ONLY

Holley Terminator X Max ECU

MF Kustoms Plug&Play Adapter

MF Kustoms Wiring Harness

Bosch 4.9 Wideband Sensor

Power Harness

CAN-USB Laptop Tuning Cable

Optional:

3.5" Touchscreen Handheld

(System is setup to use the internal 1 bar MAP sensor for naturally aspirated combinations, however there is a terminated plug for use with external MAP sensors)

Shipping Note*

Due to low volume of order frequency for this kit we have moved these to a "made to order" basis. Please expect 1-2 weeks for shipment (possibly sooner) unless there is any back ordered components.