AF-52230 Vented Valve Cover Fittings (Pair)

A simple bolt on solution to your AFM Valve Covers needing to vent crankcase pressure to a catch can. If you have gone from a naturally aspirated setup to a forced induciton setup and need to add fittings to go to a catch can then this pair of vent fittings will work for you. No welding required! 

This is for a pair (qty 2) breather vent 10an (male) fittings

Simply drill a 11/16" hole on your valve cover, remove the locking nut, then place the fitting assembly through the hole and use thread on the locking nut to compress the included o'ring seal. 

Use the allen head screw to secure the locking nut from turning to insure 100% seal

Height Inside Valve Cover: 0.710 in. (before o-ring compression)

Note* Be sure to check and confirm you will not interfere with the rocker arm inside the valve cover - best placement will be between the peak of the cover and the rocker arm or in between two rocker arms.