AFM-0102 POWER PIPE® ,VORTECH 94-95 Instruction
P.O. BOX 638 RT 10 WEST CLINTON, IL 61727 217-935-2384
AFM-0102 POWER PIPE® ,VORTECH 94-95 INSTRUCTIONS
This product is for off road use only
Thank you for purchasing an AFM product. If you have a S-Trim Vortech making 10lb of Boost or more, you should see a boost increase of 1 to 3lb without having to spin the supercharger any harder which means more boost without more heat which equals more h.p..
First you will need to get a 1 inch heater hose 2 1/2 ft long for the new hook up for the air bypass.
1. Remove supercharger compressor, inlet tubing, act sensor and mass air.
2. You will need to make a 4 1/2” hole in the inner fender. There is not one on the 94-95. There is a hole further forward and you will be cutting into when, making the new 4 1/2” hole.
3. The best way to make the new hole is.
a. Place the open end of metal part of the Power Pipe® (the part that goes into the rubber elbow) up to the inner fenderwell 3/4” from the shock tower and 3/4” from the top of the fenderwell and take a marker and trace around it.
b. With a hand air grinder cut this out to 4 1/2”. When you are done, this opening will be up to the ledge of the inner fender where the metal is doubled and against the shock tower. Be careful any lower will be into the plastic fender liner.
4. Put the Power Pipe® through the 4 1/2” hole in the fenderwell.
5. Re-install the S/C compressor back into place.
6. Locate and install rubber elbow provided,( Note: This elbow has an insert reducer in the end that is to be installed on the supercharger for the proper fit. However, some racing superchargers ( T or YS-trim ect.) require removal of this insert to achieve the proper fit )
7. Slide the Power Pipe® into rubber elbow on compressor. Do not tighten clamps.
8. Locate rubber hump hose provided, install act sensor in the 7/16” hole.
9. Slide hump hose from the bottom inner fenderwell onto the Power Pipe®. with act sensor facing engine compartment.
10. Install mass air, slip this up from the bottom inner fenderwell onto the hump hose.
11.Tighten all hose clamps.
12. Plug in mass air wiring and ACT sensor. The wires should reach, if not unwrap from wire lume and this will give you more length.
13. Screw in the air by-pass elbow provided and hook up by-pass
For questions regarding this installation please call the AFM Tech Line at 1-217-935-2384
To increase the air flow through your new AFM Power Pipe® , we strongly suggest the use of one of our AFM Power Stack air cleaners which flow 10-20% more than conventional conical air cleaners. For pricing and availability, please call our order line at 1-800-234-3106.