Gate-Way Terminator X Kit for the 1999-2004 Mustang GT/Cobra

The new Gate-Way for the 1999-2004 Mustang GT & Cobra is your connection to all the great feature and tuneability of the Holley EFI ECUs without losing the major functions of the factory dash and accessories of the Mustang GT& Cobra.
 
The Gate-Way plugs right into the OEM connectors that is located in your passenger kick panel that originally plugged into the factory ECU. Then the Gate-Way harness runs under the carpet and mounts the Holley EFI under your seat. No need to do any custom wiring. 

Hook up your power leads, wide band sensor and MAP sensor. Then you are ready to go.

The included wiring harness uses a CAN connector to accept handhled tuning monitors or the USB to CAN cable for laptop tuning (*optional cable select above)

Once you have installed the Gate-Way/ Holley EFI and have it setup on your car. You can switch to the Gate-Way/ Holley EFI from factory ECU at the track in about 15 minutes.
Then back to Factory ecu for the ride home.

This kit we've assembled gives you everything you need to install and work the Gate-Way on your 1999-2004 Mustang GT/Cobra.

For naturally aspirated vehicles you will use the Holley's onboard 1 bar internal MAP sensor. All supercharger or turbocharged applications will need to select the external MAP sensor above.

Note* For 2003-2004 Supercharged SVT Cobras you will need to select the 3-Bar MAP sensor above.

Will NOT work for returnless fuel systems.

This is for manual transmission vehicles only

The Gate-Way software will allow you to adjust your speedometer for gear or tire changes  (Download for software below)

Software Download

Kit components include:

Gate-Way device

Wiring Harness

Holley Terminator X ECU

Main Power Harness

Holley Coil Drivers (For stock Ford modular coils)

Bosch Wideband O2 Sensor

3-Bar MAP sensor (optional)

CAN to USB cable for laptop tuning (optional)