N-41 Camshaft 2600-6200 Range
- Out of Stock
- Calculated at Checkout
N-41 Camshaft works with stock OEM pistons with 1.6 roller rockers. RPM range 2600-6200.
302 c.i.d. This cam is to be used with 1.6 R.R. Best cam for GT-40. Great with TFS or Edelbrock heads. Minimum 24lb injectors and 75mm mass air. Recommend 3.73 to 4.30 gears. Good drivability down to 2100 rpm, lumpy idle, rpm range 2600-6200, works best with 89-93 EEC, needs 2800-3000 converter.
EXAMPLE of using N-41 camshaft
Stock short block, TFS T.W. Heads, N-41 camshaft, TFS Track Heat, 30# injector, 70mm T.B. MSD 6al, PMS, BBK 1.625" long tubes, BBK Cold Air Kit, 75mm Bullitt Mass Air, 93 oct fuel.
Fits the following cylinder heads with stock OEM pistons from 87-95 5.0L
AFR-1399 Air Flow Research Renegade 165cc with 1.9 valves
TFS-51410002-M61 TrickFlow 170cc Twisted Wedge with 2.02 valves
TrickFlow 170cc 11R with 2.02 valves
ED-60225 Edelbrock Performer RPM 170cc with 1.9 valves
GT40 Iron with stock size valves
GT40 3 Bar Iron with stock size valves
OEM E7 Iron with stock size valves
This cam is the best sounding cam for the foxbody Mustang . Sounds way better then my previous B303 cam, nice rough idle. Pulls hard from 2300- all the way to 6400 RPM. Had no issues with piston to valve clearance installing on my stock bottom end and good drivability
Best sounding cam hands down for a stock bottom end 302. It's kinda dead out of the hole but once above 3500 rpm hold on...it's like it never stops pulling! Anderson cam customer for life now.
I was very pleased with the staff at Anderson for being so patient with me in choosing the right camshaft for my set up. Ordered the camshaft and it showed up at my door three days later. Excellent customer service and shipping! I will defiantly order from them again.